Iowa Mold Tooling Co., Inc.: Safety Recalls in 2017

Updated on March 19, 2026.

There were 3 safety recalls made by Iowa Mold Tooling Co., Inc. in 2017. See the details of the recalls below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

See this for other years:

November 13, 2017

(Campaign #: TB2017008)

Stabilizer Pin Locking Arm Pin Incorrect

Iowa Mold Tooling Co., Inc. (IMT) is recalling certain Dominator I Crane bodies sold for installation onto other chassis. These cranes have incorrect stabilizer arm locking pins that may not engage properly allowing the stabilizer arm to extend from the side of the vehicle while traveling.

NHTSA ID: 17E067000

Component:

# of Units Affected: 19

Consequence Summary:

If the locking arm pin does not engage, the stabilizer arm may extend while the vehicle is in motion, increasing the risk of a crash.

Corrective Action:

IMT will notify owners, and dealers will replace the incorrect pin with a correct length pin, free of charge. The recall began on December 20, 2017. Owners may contact IMT customer service at 1-800-247-5958. IMT's number for this recall is TB2017008.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 57.89

View Full Recall Details

August 18, 2017

(Campaign #: TB2017006)

Jump Start Plug Kit Fuse Block Electrical Short

Iowa Mold Tooling Co., Inc. (IMT) is recalling certain 2016-2017 Dominator Contractor series trucks built on 2017 Ford Super Duty chassis. These vehicles are equipped with a front jump start plug kit installed under the hood at the chassis battery. The fuse block for this kit may contact the hood creating an electrical short.

NHTSA ID: 17V515000

Component:

# of Units Affected: 38

Consequence Summary:

An electrical short can increase the risk of a fire.

Corrective Action:

IMT will notify owners, and dealers will replace the jump start kit mounting bracket, thereby relocating the fuse block, free of charge. The recall began on September 29, 2017. Owners may contact IMT customer service at 1-800-247-5958. IMT's number for this recall is TB2017006.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 100

View Full Recall Details

March 23, 2017

(Campaign #: 16E-092)

Corrosion of CNG Fuel Hose may cause Fuel Leak

Iowa Mold Tooling Co., Inc. (IMT) is recalling one model year 2013 Refuse-Container Delivery vehicle, equipped with a compressed natural gas (CNG) fuel system by Agility Fuel Systems. The affected CNG system has flexible stainless steel, sleeved, high pressure hoses that may corrode from exposure to environmental conditions such as water mixed with road salt.

NHTSA ID: 17V208000

Component: FUEL SYSTEM, OTHER

# of Units Affected: 1

Consequence Summary:

Corrosion of the fuel hose may result in a CNG leak, which in the presence of an ignition source, may increase the risk of a fire.

Corrective Action:

IMT will notify the owner and instruct them to contact Agility to have the defective hose assembly replaced free of charge. The recall began on May 4, 2017. Owners may contact IMT customer service at 1-800-247-5958, or Agility customer service at 1-888-686-7278. IMT's number for this recall is 16E-092.

Park Outside Advisory: No

Do not Drive Advisory: No

Completion Rate (%): 100

View Full Recall Details