OLD H.G., INC.: Safety Recalls in 1991

Updated on March 19, 2026.

There was 1 safety recall made by OLD H.G., INC. in 1991. See the detail of the recall below.

You can also see similar information for other manufacturers.

Data Source: NHTSA.

December 6, 1991

(Campaign #: NR (Not Reported))

EQUIPMENT:OTHER PIECES

THE BOLT HOLDING THE TONGUE TO THE FIRST CROSS BRACE "U" MEMBER MAY PULL THROUGH BECAUSE OF AN IMPROPERLY SIZED HOLE IN THE CROSSMEMBER.

NHTSA ID: 91V212000

Component:

# of Units Affected: 24,651

Consequence Summary:

AN IMPROPERLY SIZED BOLT HOLE WOULD REDUCE THE CLAMPINGFORCE BETWEEN THE TONGUE AND CROSSMEMBER, ALLOWING THE TONGUE TO PIVOT BETWEENTHE BALL HITCH AND THE SECOND CROSS BRACE. THIS COULD RESULT IN THE TRAILERJACKKNIFING, AND LOSS OF CONTROL OF THE TRAILER.

Corrective Action:

INSTALL A FLATWASHER IN THE OUTSIZED BOLT HOLE TO INCREASE THE CLAMP FORCE BETWEEN THE TONGUE AND FIRST CROSSMEMBER.

Park Outside Advisory: No

Do not Drive Advisory: No

View Full Recall Details