Martin's Pork Products, Inc.: Non-Compliance to Humane Livestock Handling in 2025 (USDA)
See the detail of the non-compliance of humane livestock handling that the USDA observed at the Martin's Pork Products, Inc. slaughterhouse establishment in 2025.
You can also see other establishments that were non-compliant in 2025.
313.1
313.1
On July 11th, at approximately 7:30am while performing a Humane Handling task at Martin's Pork M6720, I observed the following noncompliance. While performing ante mortem inspection I observed two small holes (approximately 1 inch in diameter) on the livestock loading/ unloading ramp. One hole was located at the bottom of the ramp and one hole was near the top of the ramp. Approximately halfway up the ramp I observed a broken metal bracket and 4 round bolt heads that were not sitting flush with the wooden steps. I notified Mr. REDACTED (HACCP coordinator) of the noncompliance and the failure to meet regulatory requirement 9 CFR 313.1.
313.1
On March 5th 2025 at Martin's Pork (6720) while performing an Ante Mortem Inspection HATS category IV of the Humane Handling verification task the following noncompliance was observed at approximately 11:15am. Inside the barn with the knocking box in the back of pen #2 there is a panel with approximately three rusty holes that have jagged edges, therefore pen # 2 was not maintained in good repair. Mr. REDACTED (HACCP Coordinator) was notified of the noncompliance and the failure to meet regulatory requirement 9 CFR 313.1.
